1. (TCO 5) This is the port state that can send and receive data frames: _____. (Points : 5)
disabled state
forward delay
forwarding state
hello time
2. (TCO 5) The number of switches that a frame has to traverse to travel between the two farthest points within a broadcast domain is known as what? (Points : 5)
Root ports
Spanning Tree Protocol
Spanning-tree algorithm
Switch diameter
3. (TCO 5) In this state, sending and receiving BPDUs occurs but addresses are not learned nor frames forwarded. (Points : 5)
Listening state
Maximum age
Nondesignated ports
PortFast
1. (TCO 6) When implementing a router-on-a-stick, what is necessary for establishing communication between VLANs? (Points : 5)
Multiple switch ports to connect to a single router interface
Native VLAN IP address that is configured on the router interface
All trunkports configured in access mode
Router interface
2. (TCO 6) Select the answer that is NOT a valid method of implementing inter-VLAN routing? (Points : 5)
Spanning-tree routing
Router-on-a-stick
Multilayer-switch-based routing
None of the above
3. (TCO 6) On a router, the interface that is to be used as the trunk CANNOT be which of the following? (Points : 5)
100-Mbps Ethernet
Gigabit Ethernet
10-Gigabit Ethernet
10-Mbps Ethernet
4. (TCO 6) A Trunk port carries traffic for multiple VLANs using Inter-Switch Link (ISL) encapsulation or _____ tagging. (Points : 5)
802.1Q
801.2Q
801.1Q
None of the above
1. (TCO 4) The _____ integrates information about the print file with information obtained from the printer driver installed at the client for the target printer, in a process that Microsoft calls rendering. (Points : 4)
GDI
spooler
print driver
print scheduler
2. (TCO 4) When the spool file is fully formatted for transmission to the printer, the print _____ pulls it from the spooler’s disk storage and sends it off to the printer. (Points : 4)
spool
monitor
driver
queue
3. (TCO 4) The setup information that you specify while stepping through the Add Printer Wizard can be modified and further tuned by accessing the _____ dialog box for a printer. (Points : 4)
Tuning
Properties
Advanced
Configuration
1. (TCO 4) A print _____ is like a stack of print jobs, with the first job submitted at the top of the stack and the last job submitted at the bottom and all the jobs waiting to be sent from the spooler to the printer. (Points : 4)
spool
queue
driver
server
2. (TCO 8) A(n) _____ partition is one from which you can boot an operating system, such as Windows Server 2008. (Points : 4)
active
extended
secondary
primary
3. (TCO 8) A _____ volume is stored on two to 32 dynamic disks that are treated as one volume. (Points : 4)
striped
mirrored
spanned
simple
1. (TCO 8) The process of _____ locates fragmented folders and files and moves them to a location on the physical disk so they are in contiguous order. (Points : 3)
fragmenting
defragmenting
partitioning
formatting
2. (TCO 8) A RAID-5 volume requires a minimum of _____ disk drives. (Points : 3)
two
three
four
five
3. (TCO 4) When the spool file is fully formatted for transmission to the printer, the print _____ pulls it from the spooler’s disk storage and sends it off to the printer. (Points : 4)
spool
monitor
driver
queue
